discoveryhaser.blogg.se - L298n motor driver power supply

#L298N MOTOR DRIVER POWER SUPPLY DRIVERS#
#L298N MOTOR DRIVER POWER SUPPLY DRIVER#

#L298N MOTOR DRIVER POWER SUPPLY DRIVER#

It is a dual channel H bridge motor driver which can be easily used to drive two motors. The L298N Motor driver IC is powerfully built with a big heat sink. The diagram below shows all the components consisting inside the module. The L298N motor driver module consists of a L298N motor driver IC ,78M05 5V regulator, 5V jumper enable, power LED, heat sink, resistors and capacitors all combined in an integrated circuit. This module is mainly used in robotics and in controlling dc and stepping motors. Thus, it is perfect for two wheeled robots. It is widely used in controlling robots as we can connect up to four motors at once but if we want to control the speed and direction as well than it allows two motors to be connected. For this project, we will be using L298N motor driver module as it very easy and relatively inexpensive as well.

#L298N MOTOR DRIVER POWER SUPPLY DRIVERS#

Flash MicroPython Firmware with esptool.py to ESP32 and ESP8266 L298N Motor Driver Moduleĭc motors can be controlled through several drivers which are widely available in the market.

MicroPython ESP32 and ESP8266: Program with VS Code and Pymakr.

If you want to use VS Code, you can follow this guide:

Getting Started with Thonny MicroPython IDE for ESP32 and ESP8266.

Getting Started with uP圜raft IDE on ESP32 and ESP8266.

MicroPython Script: main.py to control DC Motorīefore we start this lesson make sure you are familiar with and have the latest version of MicroPython firmware installed in your ESP boards and have a running Integrated Development Environment (IDE) in which we will be doing the programming such as uP圜raft IDE or Thonny IDE.

Uploading L298N Motor Drive Library in Thonny IDE.

Creating L298N Motor Driver Library in MicroPython.

Interfacing DC Motor & L298N motor Driver with ESP32 and ESP8266.

Controlling DC motors through L298N module and MicroPython.